Garage Floor Coating in Gallatin, TN
Bought new in Gallatin, or close to it? Your garage slab is probably young, and it still needs the right prep. Every garage floor coating we install starts with a diamond grind and a moisture test and ends as a flake floor under a lifetime adhesion warranty. The estimate is free, at your house.
- Free on-site estimate
- Moisture test included
- Park after 72 hours
- Lifetime adhesion warranty
Gallatin garage floor coating, explained
Your garage floor coating goes down in layers. We diamond-grind the slab and repair the cracks and joints, then roll on a polyurea base coat and broadcast vinyl flake until no gray shows. A clear polyaspartic topcoat with a little grit locks it in and keeps your footing.
Before we price anything, we moisture-test your slab. If it needs the barrier primer, that cures overnight and your install runs two days instead of one. You can walk on the floor the next morning and park on it after 72 hours.
Shopping for epoxy flooring in Gallatin, TN? Ours is the next step up. You get the look of a flake epoxy floor and the same prep, but it sets in a day, flexes with your slab and won't turn yellow by the door. Epoxy vs. ours.
Every floor we install carries a lifetime adhesion warranty, and the prep is why we can stand behind it. A coating holds on hard to concrete that has been ground open and checked for moisture.
Odds are your slab is young
Gallatin is one of the fastest-growing cities in Tennessee, and most of its homes have gone up since 2000. If you bought one of the new houses off Hartsville Pike, you may even have watched your garage slab get poured.
That's good news for your floor. A younger slab usually has fewer cracks to fill and rarely any old paint, so the prep tends to go quickly and adds less to your price.
The older streets around the historic square are the exception. Those slabs have more years on them, some are painted, and a few have seen creek water, so the moisture meter does more of the deciding there.
Either way, you'll know exactly what your slab needs, and what it costs, before you spend a dollar.
Four things to know about your new slab
- It has to be 28 days old. Fresh concrete needs that long to cure before any coating goes on. Most homes are past it by closing, but if your garage was poured last, ask your builder.
- It still gets ground. Builders trowel garage slabs hard and smooth, and many spray on a cure-and-seal. A coating can't grip either one. Splash a little water on your floor. If it beads up, there's a sealer.
- Hairline cracks are normal. New concrete shrinks as it cures, and the cut joints are there to steer the cracks. We fill them and grind them flush. A crack wider than a quarter inch, or one with a raised edge, needs concrete repair first, and we'll point it out at your estimate.
- Empty is easy. A garage with no boxes, bikes or shelves yet makes for the simplest install day there is. If you can, coat it before you move in.
Which Gallatin garage do you have?
We cover all of Gallatin, from the lake to the newest streets off Hartsville Pike. Find yours below, since each kind of garage asks for a slightly different job.
Lake and golf
Fairvue and Foxland
In Fairvue Plantation and Foxland Harbor, your golf cart may come home with wet grass on its tires. Some garages hold a boat off Old Hickory Lake, too. The grit in the topcoat keeps your footing, and the mess hoses out.
Newer subdivisions
Kennesaw to Carellton
In Kennesaw Farms, Carellton and the streets off Big Station Camp Boulevard, your slab is likely young and sealed by the builder. It needs the grind and the moisture test, and usually only a little crack repair.
Around the square
Older Gallatin
Near the historic square and along Town Creek and East Camp Creek, your concrete has more years on it. It may be painted, and some of it has seen floodwater, so your moisture reading carries the most weight here.
Don't see your street? We also cover Savannah, Stratford Park, Cambridge Farm, Langford Farms, Peach Valley, Lock 4, Bellsford Landing and the rest of Gallatin, plus Hendersonville, White House and Goodlettsville next door.
May rain, January salt
May is Gallatin's wettest month, and some Mays bring more than rain. Station Camp Creek has flash-flooded, and Town Creek, which usually runs dry, has overflowed into a nearby neighborhood. If your house sits low by a creek, you may have pushed water out of your garage yourself.
When water does get in, a coated floor keeps the mud and silt on the surface, where a hose and a squeegee clear them. A coating can't stop floodwater, though, so fix the downspouts and grading first. After a flood, we let your slab dry and let the meter decide on the barrier.
In winter the trouble is ice. City salt trucks work Big Station Camp, Kennesaw and Foxland boulevards, and your tires bring that salt home. On your coated floor it mops right up instead of leaving white marks.
What your install day looks like
A Gallatin garage floor coating takes one working day on a dry slab. Add the moisture barrier and it's two, because that primer cures overnight.
-
A free estimate first
We spend about 20 minutes at your house measuring, taking moisture readings and checking the cracks and joints. You get a written, itemized price and all the time you want to decide.
-
Grinding the whole slab
Diamond grinders open the surface, with dust collection running and the edges done by hand. If your slab is new, this is the step that takes the builder's sealer off.
-
Cracks, joints and the barrier
We fill the cracks and control joints and grind them flush. If your slab needs the moisture barrier, the primer goes on now and cures overnight, and your floor gets finished the next day.
-
Base coat and full flake
Next comes the polyurea base coat in the color you picked. While it's still wet, we throw vinyl flake across it until it can't hold any more.
-
Clear topcoat, then hands off
We scrape off the loose flake, vacuum and roll on the clear polyaspartic topcoat with anti-slip grit. You can walk on it the next morning and park after 72 hours, and it keeps hardening for a week or more.
Gallatin garage floor coating cost
- $2K–$4.5Kmost two-car garage quotes
- $3.5K–$6.5Ka typical three-car garage
Those are typical prices around Nashville, and your own number depends on your garage. Size matters most. After that come crack repair, any paint or old coating that has to come off, and the moisture barrier if your slab calls for it. Cove base and steps add a bit more.
Newer slabs often need less repair than the older ones near the square, which helps keep your price down. You get the exact figure in writing at the free estimate. How pricing works around Nashville.
The same floor, in more rooms than one
The flake floor we put in garages also goes into shops, basements, kitchens and covered porches. Browse the gallery, or try a color on a photo of your own garage.
Gallatin garage floor questions
How much does garage floor coating cost in Gallatin?
Around Nashville, a professionally installed flake floor typically runs about $5 to $9 a square foot. Your number moves with the size of your garage, crack repair, paint removal, the moisture barrier, cove base and steps. We measure and test the slab at a free estimate and give you the exact price in writing. Cost guide.
How soon can a new garage slab be coated?
Once the concrete is at least 28 days old, which most new homes are by closing. We still take moisture readings, because new concrete can hold water for a while. The easiest time is before you move in, while your garage is empty. The install takes one working day, or two if your slab needs the moisture barrier.
Does a brand-new garage floor need grinding?
Yes. A new slab is troweled hard and smooth, and many builders spray a cure-and-seal on top, which leaves nothing for a coating to bite into. The diamond grind takes off the sealer and that slick top layer and opens up the concrete, so your base coat bonds into it.
Are cracks in a new garage floor normal?
Hairline ones are. Concrete shrinks as it cures, and the cut control joints are there to steer those cracks. We fill them and grind them flush before your base coat goes down. A crack wider than about a quarter inch, one with a raised edge, or one that keeps growing means the slab moved. That needs concrete repair first, and we'll tell you at the estimate.
Our garage took on water in a storm. Can it still be coated?
Usually, yes. Let the slab dry out first. At the estimate we take moisture readings and look for damp patches and white chalky deposits. A high reading or two signs puts the moisture barrier primer in your job. Keep in mind that no floor coating keeps floodwater out. It does keep mud and silt on the surface, where a hose clears them.
Do you install epoxy flooring in Gallatin?
No plain epoxy here. Your floor starts the way a good epoxy job does, with a diamond grind and a full flake broadcast, but the coats are polyurea and polyaspartic. That swap is the upgrade. It sets the same day, gives a little as your slab moves and stays clear in sunlight. You can park after 72 hours instead of a week.
Do you coat porches and patios too?
Yes. The same kind of flake floor works on a covered porch, a patio or a walkway, and on a new house it can tie your front porch to the garage. Outdoor slabs get the same grind and repair first. Patio and porch coatings.
Which parts of Gallatin do you cover?
All of Gallatin: Fairvue Plantation, Foxland Harbor, Kennesaw Farms, Carellton, the Station Camp area, Savannah, the streets around the square and the newer ones off Hartsville Pike. Next door, we cover Hendersonville, White House and Goodlettsville too, plus the rest of the Nashville area, and your estimate costs nothing.
Get a written price for your Gallatin garage
Book a free estimate. We'll measure, test your slab for moisture and leave you an itemized price, whether your house is brand new or decades old. You never have to sign on the spot.