Your garage near the lake works hard. Boats drip lake water on the floor, and summer tires roll in hot. Our Hendersonville garage floor coating starts with a moisture test and a diamond grind, and ends with a flake floor you can mop clean. Free estimate at your house, lifetime adhesion warranty.
You get a brand-new top surface on your slab. We diamond-grind the concrete, fill the cracks, roll on a polyurea base coat and bury it in vinyl flake. A clear polyaspartic topcoat with a little grit seals it all in.
Before any of that, we test your slab for moisture. If it needs the barrier primer, that goes down first and cures overnight, so your install takes two days instead of one. Either way, you walk on the floor the next morning and park after 72 hours.
Shopping for epoxy flooring in Hendersonville? What we install is the step up from an epoxy floor. It gets the same prep and the same flake look, but it cures in a day and won't yellow in the sun. How the two compare.
Can't picture it in your own garage? Snap a photo and try a few flake colors on it with our color preview. Then book the free estimate, and we'll test your slab and price the floor in writing.



Hendersonville has 26 miles of Old Hickory Lake shoreline inside city limits. If you live anywhere near it, your garage probably doubles as a boathouse, and bare concrete makes a poor one.
Say it's a Sunday in July. You pull the boat out at Sanders Ferry Park and back the trailer into the garage. Lake water runs off the hull, and the life jackets drip from their hooks all night.
Bare concrete soaks up every drop, and a gas or two-stroke spill leaves a stain that won't scrub out. A coated floor keeps all of it on the surface. Monday morning, you squeegee the water out the door and wipe the gas spot with a rag.
Keep that up all season, and the floor you walk on in October looks like the one you had in May.

Here's how your coated floor handles the four things a lake garage throws at it. One of them needs a little help from you.
A tongue jack parks the front of your boat on a few square inches. Left in one spot all winter, it can dent any coating, ours included. Set it on a wide pad or a plywood square.
Life jackets and wet towels drip wherever they land. On your coated floor the water beads up and mops away, and the grit in the topcoat keeps your feet under you while it's wet.
Gas cans and two-stroke oil drip sooner or later, and bare concrete drinks every drop into a stain. Your clear topcoat holds the spill on the surface until you wipe it up with a rag.
Tires off hot July pavement can soften paint and thin DIY kits and pull them up. A cured polyurea and polyaspartic floor holds. Give yours the full three days before you park.
Some spring mornings you'll find your garage floor wet when nothing spilled. Warm, humid air rolls in after a cold snap and beads up on the cool slab, the way a glass of iced tea sweats on the porch.
Bare concrete soaks that water in and gets slick. On your coated floor it wipes off in a minute. We also check the dew point on install day, so your coating goes down on a slab that's ready for it.
Winter brings the salt. When ice is on the way, TDOT treats Main Street and Vietnam Veterans Boulevard, city trucks salt the bridges and hills, and your tires carry it all home. On bare concrete it soaks in and leaves white marks. On your coated floor, a quick rinse after the storm takes care of it.

The year your house went up tells us a lot about the concrete under your car. Find your decade, and you'll know what your job might include before we pull into the driveway.
In Lakeside Park and the older parts of Walton Ferry and Sanders Ferry roads, we assume your slab has no plastic under it. That counts as one moisture sign, so your meter reading carries extra weight.
Built in the '70s? You've got company. More of today's Hendersonville homes went up that decade than any other, including the ranches on the Indian Lake Peninsula. Expect old oil stains, maybe some paint, and the same moisture caution.
Slabs from these years tend to show hairline cracks and a few stains. Some carry an old sealer or a peeling DIY kit, and that has to come off before anything new can grip. If yours does, you'll see it listed on your estimate.
In Durham Farms and other newer neighborhoods, your slab is probably hard and smooth, often with a builder's sealer the grind takes off. Once the concrete is 28 days old, the best day to coat it is before the moving truck shows up.


Installing a garage floor coating in Hendersonville takes one working day on a dry slab, two if yours needs the moisture barrier.
We come out for about 20 minutes, measure your garage, take moisture readings and look over the cracks. You get a written, itemized price before we leave.

Diamond grinders open the whole slab, edges by hand. Cracks and joints get filled and ground flush. If you need the barrier primer, it cures overnight.

Your polyurea base coat goes down in the color you picked. While it's still wet, we broadcast vinyl flake across it until the floor won't take any more.

We scrape and vacuum the loose flake, then roll on the clear polyaspartic topcoat with anti-slip grit. You can walk on it the next day and park after 72 hours.

Here's what a professional flake floor typically costs around Nashville. Your own price comes after we've measured and tested your garage.
A few things move your number. Size comes first, and a small garage costs more per foot because the setup is the same. Then come cracks to fill, old paint to grind off and the moisture barrier if your slab needs one.
Cove base and coated steps add a little more. You get the exact figure in writing at the free estimate, and nobody pushes you to sign that day. See the full cost guide.

We install garage floor coatings all over Hendersonville. That covers zip code 37075, from the lake peninsulas to the newest streets off Drakes Creek Road. The estimate always happens at your house.
Don't see yours? If you're in Hendersonville, we cover you. Next door, we also install in Gallatin, Goodlettsville, White House and the rest of the Nashville area.

A few of the flake blends you can choose, from harbor blue to driftwood. See the full gallery, or preview a color on a photo of your own garage.







Around Nashville, a professionally installed flake floor usually runs about $5 to $9 a square foot. Where yours lands depends on the size of your garage, the cracks, any old coating to grind off and whether the slab needs the moisture barrier. We measure and test it at a free estimate and leave you the exact price in writing. More on cost.
Yes. Trailer tires are fine once the floor has fully cured. Watch the tongue jack, though. It puts a lot of weight on one small foot, and over a long winter that point load can press a dent into any coating. Set it on a wide pad or a square of plywood, and wipe up fuel drips when you spot them.
No. Age alone doesn't rule your slab out. We assume a house that old has no plastic vapor barrier under the concrete, which counts as one moisture sign. Then we meter it and look for others, like white chalky deposits or damp patches. A high reading or a second sign adds the barrier primer, and a second install day.
We don't install plain epoxy. What goes down in your garage is the upgrade over an epoxy floor. It gets the same diamond-ground prep and full flake look, with a polyurea base coat and a clear polyaspartic topcoat. It cures in a day, flexes as your slab moves and stays clear in the sun. You park after three days instead of a week.
One working day on a dry slab, or two when your slab needs the moisture barrier, since that primer cures overnight. Every Premium floor includes the barrier, so a Premium install always takes two days. Walk on it the next morning and park after 72 hours. Go easy dragging heavy things that first week.
Usually it's condensation. When a warm, muggy day follows a cold snap, your slab is still cold, and the moisture in the air settles on it. Bare concrete absorbs it and stays damp for hours. A coated floor keeps the water on top, where a squeegee clears it, and the grit in the topcoat helps your footing.
Yes. Plenty of lake lots slope toward the water, and some homes have a walk-out basement or a lower-level garage. A floor that sits partly below the ground outside carries more moisture risk, so your meter reading matters even more. The same coating works there, with the barrier primer when your slab calls for it. Basement floors.
All of it, from the Indian Lake Peninsula, Sanders Ferry and Lakeside Park to Saundersville, Durham Farms and every street in between. We also cover Gallatin, Goodlettsville, White House and the rest of the Nashville area. Your estimate is free and happens at your house, and you keep the written price.
Book a free estimate at your Hendersonville home. We'll measure, test the slab and leave a written, itemized price, with no pressure to sign. Prefer photos? We can quote online too.